0 Members and 1 Guest are viewing this topic.

*

Offline jknightg1

Noisy when put in low gear
« on: August 11, 2017, 12:10:19 pm »
Sometimes when I put the quad in low gear it rattles and clanks and snatches before going. It sounds like gear teeth slipping.

Any advice appreciated


regards

John

*

Offline Cosmosdan

Re: Noisy when put in low gear
« Reply #1 on: August 11, 2017, 06:16:04 pm »
I would make sure the shift linkage is adjusted correctly.
2013 Z6 Trail
Iron Baltic skid plates
UE Boom Speaker mount
RZR 800 Shocks
Mostly stock trail riding
25g. Rollers and A1

2016 Outlander max 570
Too new for mods yet

*

Offline PowersportsRO

Re: Noisy when put in low gear
« Reply #2 on: October 04, 2017, 02:21:06 pm »
We have one unit under 500km low gear won`t gear in. It only makes a nasty sound. We check the linkage even tried to force the rod with the hand to get in low range but no luck. We tried also with low rpms still no luck. Any ideas before we start disassembly ?? Thanks.

*

Offline NMKawierider

Re: Noisy when put in low gear
« Reply #3 on: October 04, 2017, 03:08:28 pm »
We have one unit under 500km low gear won`t gear in. It only makes a nasty sound. We check the linkage even tried to force the rod with the hand to get in low range but no luck. We tried also with low rpms still no luck. Any ideas before we start disassembly ?? Thanks.
Remove the linkage completely and try it just with the arm on the transmission. If it still won't you probably have a bent shifter fork in the transmission...probably from someone trying to shift it into low while still moving.
2015 Z Force 800 (53") EPS -
Custom Air Intakes | Custom Exhaust Mod | SuperATV Harness | Custom Fenders | Custom Skid/Rock Sliders | 27" GBC Grim Reapers | Seizmik Mirrors |Конструктор (Rodin's) Doors | Dr Pulley Sliders | 1.5" Wheel Spacers | BENZ Silencer (as needed) | SATV Flip Windshield W\ Rear Shield | Dual Light Bars | Diamond Plate Storage | Magellan TRX7 GPS| Bandit Springs

My Videos On YouTube